Mountz PULSE TOOLS Spezifikationen PDF herunterladen (Seite 12)

Operation (cont.)

SETTING GO AND NO/GO TOLERANCE (High/Low) LIMITS

In the Peak, Power Tool or First Peak mode:

1. Press the Tolerance key (the arrow icon will point to Low Tolerance).

2. Change the value of the flashing digit by pressing the Scroll Up key (and the decimal will be fixed).

3. Scroll to the next digit by pressing the Scroll Right key.

4. Press Enter to save the low limit and display the High Tolerance limit.

5. Repeat to set the High limit. Press Enter when finished.

The TorqueMate® Plus will now activate the Green LED and buzzer when reaching a peak over the low

limit, and will activate the Red LED and buzzer when going over the high limit.

In Angle mode:

First enter the threshold torque then the angle tolerance.

1. Press the Tolerance key to display the threshold torque (depicted by torque

threshold in window).

2. Change the value of the flashing digit by pressing the Scroll Up key.

3. Change to the next digit by pressing the Scroll Right key.

4. Press the Enter key when the correct digits are selected for torque threshold.

5. Now set the angle high/low tolerance.

6. Set the low angle tolerance with the Scroll Keys.

7. Press Enter to save the low angle limit.

8. Repeat for the high angle limit.

9. Press Enter to save the high angle limit and return to the operation mode.

The TorqueMate® Plus display will now track the applied torque until the

threshold torque is reached and then begin monitoring the angle. When the

low angle is limit is reached the green LED will illuminate. When the High

angle limit is reached the Red LED will illuminate. When the peak angle is reached the torque at that

angle will now be displayed.

Break Away ( Using the Angle mode)

To check breakaway (first movement) of a fastener: The TorqueMate® Plus will enter a special breakaway

sensing mode when you set the low angle tolerance to a small value, usually 1 to 3 degrees, and the high

angle tolerance to zero

. Apply torque to an already tightened fastener, when the TorqueMate® Plus senses

the threshold torque (set at approximately 50% of the expected torque) it will start looking for the fastener to

move the number of degrees set as the low tolerance. When this number of degrees has been reached it

will automatically capture the torque at that point and will disregard any further torque input, even if you

keep turning the fastener.

Note: Use of Go/NoGo

Be sure to set a tolerance if you want to use the Go/No Go feature.

The Go/No Go feature is not active when in the Track Mode.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Keine Kommentare

Mountz PULSE TOOLS Spezifikationen Seite 12